Table of Contents
Advertisement
3.5" Mainboard Manual
Video Off Method
This option determines the manner when the monitor goes blank.
The Choices:
V/H SYNC+Blank (Default)
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS Support
Initial display power management signaling.
Modem Use IRQ
This determines the IRQ, which can be applied in MODEM use.
The Choices: 3 (Default) / 4 / 5 / 7 / 9 / 10 / 11 / NA
Soft-Off by PWRBTN
This item determines the behavior of system power button. Instant off
turn off the power immediately, and Delay 4 Sec. will require you to
press and hold the power button for 4 seconds to cut off the system
power.
The Choices: Delay 4 Sec / Instant-Off (Default)
Run VGABIOS if S3 Resume
Choosing Enabled will make BIOS run VGA BIOS to initialize the VGA
card when system wakes up from S3 state. The system resume time is
shortened if you disable the function, but system will need AGP driver to
initialize the card. So, if the AGP driver of the VGA card does not support
the initialization feature, the display may work abnormally or not function
after S3.
The Choices: Auto (Default) / Yes / No
Ac Loss Auto Restart
This setting specifies how your system should behave after a power fail
or interrupts occurs. By choosing off will leave the computer in the power
off state. Choosing On will reboot the computer. Former-Sts will restore
the system to the status before power failure or interrupt occurs.
The Choices: Off (Default) / On / Former-Sts
48
Advertisement
Table of Contents
