Installing Ceiling Mount With Lens Supporter - Optoma A16 UST Series Installation Instruction

Installing ceiling mount with lens supporter

To install this lens in ceiling mount, complete the following steps.
Notee: Due to thermal requirement, user needs to keep at least 30mm between the ceiling mount plate and bottom
intake. Furthermore, user would need to prepare adapter A, adapter B, M6 ceiling mount screws and ceiling mount
plate that are not included in the package list.
1. Remove two M6 x L22 hex screws and two M6-6.7 x 1 x 16 washers from the mounting holes.
2. Insert adapter B between the lens supporter and the ceiling mount plate, and insert adapter A between
the projector and the ceiling mount plate.
3. Fasten the ceiling mount plate onto the lens supporter using the M6 ceiling mount screws.
Ceiling mount plate
b
d
Notee:
1. Adapter A should be at least 40.1 mm long.
2. Adapter B should be the length of adapter A minus the length between lens supporter and
projector. The length between the lens supporter and projector is 15.15 mm.
3. Determine the thickness of the ceiling mount plate in order to have the length of the M6 screws
for ceiling mount. M6 screws for ceiling mount should be the length of adapter A plus thickness
of ceiling mount plate plus 10 mm.
30.00 mm
Adapter B
Adapter B
Ceiling mount screws (M6)
10.10 mm
Bottom Intake
Adapter A
Ceiling mount plate
Adapter A
c
a
English 9