Extron electronics System 8 Plus User Manual page 48

im Vertrieb von
Multiple Switcher Operation
System 8/10 P Switch Settings
LUS
Go to page 4-7 of the System 4 User's Manual to configure the master/slave as a system.
_____ Refer to the previous pages for other switch settings.
www.camboard.de
5-9
CAMBOARD Electronics
From the front access panel on the System 8/10 P
1. On DIP switch block SW15, set switches #6 and #8 "up".
2. Set rotary switch RS4 to the "0" position (RS-232 mode).
On the rear panel of the System 8/10 P
3. Set the Norm/VLB switch on the back of the 8/10 P
4. Set the Address switches for "master". (If looping two 8/10 P
System 4, the second one must be set as a "slave".)
5. Set the Video/RGBS switches to match the type of video to be used by each
input and do the configuration setup.
Tel. 07131 911201
Fax 07131 911203
Looping with System 4 xi
, do the following:
LUS
, do the following:
LUS
to "Norm".
LUS
L R L R
ce-info@camboard.de
Extron • System 8/10 P
systems to the
LUS
• User's Manual
LUS