Extron electronics System 8 Plus User Manual page 3

im Vertrieb von
System 8/10 Plus Switcher Series
Getting Started..........
uu
tt
Step 1
If the System 8/10 Plus is already configured for your model of projector, go to Step 4 . If it is
not set up correctly, it will be necessary to change switch settings on the System 8/10 Plus
Main Controller Board. Continue with Step 2 below to verify the correct configuration.
uu
tt
Step 2
Use a small screwdriver to remove the access cover from the front panel of the System 8/10
Plus. Please refer to the illustration on page 3-3 of your User's Manual.
___ Before changing anything, remove the AC power cord to the System 8/10 Plus and also turn the
projector's power off.
uu
tt
Step 3
Using the configuration information which came with your Communications Kit or is on the
switcher's label, set the System 8/10 Plus switches. The following table and diagram are to
be used only as an example of a typical configuration. Continue with Step 4 below when your
configuration is correct.
Config Model
as
Your Model
RS2
RS1
uu
tt
Step 4
Locate the Address DIP switches on the rear panel, lower right, of the switcher. Unless this is
part of a master/slave system, set #3 and #5 to the up position and the others to the down
position.
uu
tt Step 5
Please refer to the connection diagram and instructions for your projector (see your System
8/10 Plus Projector Communications Kit instructions). Using the appropriate Communications
Adapter included in your Communications Kit, connect the Comm extension cable from the
Projector Control port of the System 8/10 Plus to the Comm Adapter. Secure the Comm
Adapter to the correct projector port. Connect all other required signal cables according to
the connection diagram.
www.camboard.de
Extron • System 8/10 P
LUS
CAMBOARD Electronics
Rotary Switches
RS1 RS2 RS3 RS4
0 0 F B
ON
RS5 RS2 RS1
Configured For:
RS-232
Tel. 07131 911201
• User's Manual
Fax 07131 911203
Cable SW15 Settings
J2/J3 1 2 3 4 5 6
↓ ↓ ↑ ↓ ↑ ↓
J2
SW15 DIP Switch
RS3 RS4
ce-info@camboard.de
Comm
7 8 9 10 Adapter
↓ ↓ ↑ ↓
26-467-01
RS3
RS4