AMX Modero X Series Quick Start Manual page 2

Locking Tab Screws
Locking Tab Screws
FIG. 4 Locking Tab location on the MXA-FMK-10 (Landscape)
surface of the glass until the bottom of the panel snaps "click" to lock it
down.
Note: To help lock down the bottom of the touch panel, use a screwdriver or
other flat tool to hold the lower edge of the clear back box casing above the lip of
the main flush mount case while snapping down the bottom. For best results,
use the flat tool on one side, lock down that side, and repeat the process on the
other side.
Using the MXA-FMK-10
Once the touch panel is installed in the MXA-FMK-10, the panel may be
extended from the wall for enhanced speaker and microphone exposure and to
access the panel's Sleep/Setup button. To extend the panel from the Flush
Mount Kit, press gently on both sides of the panel's surface until you hear or feel
a "click". Release the panel to extend it.
To return the touch panel to its flush position, press again gently on both sides of
the panel's surface, on the black border on the edge of the panel, until you hear
or feel a "click". When you release the panel's surface, the panel will remain in its
flush position.
Removing the Touch Panel From the MXA-FMK-10
The touch panel may only be removed from the MXA-FMK-10 when the touch
panel is extended from the wall. For more information on uninstallation of the
touch panel in question, please refer to the Operation Reference Guide of the
panel in question, available at www.amx.com.
A Note About Wall and Rack Installation
Some products are installed in areas of differing temperature and cooling
methodologies. These include products installed in walls, racks, cabinets, etc.
Those areas may have different temperatures and/or cooling approaches that
must be taken into consideration to maintain the product within the specified
operating temperature.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
©2014 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
Use a screwdriver
or other flat tool
to hold the lower
edge of the back
box above the
case while snapping
down the touch panel.
1/14
AMX reserves the right to alter specifications without notice at any time.
FIG. 5 shows an AMX device installed in a wall with a filled volume (such as with
insulation or concrete), as well as with a closed volume (such as between studs
in an otherwise finished wall). The diagram shows how heat generated by the
device or other devices may have no way to escape, and may build up to levels
that may affect device operation.
Heat convection in filled or closed volume, limited or no convection
FIG. 5
In FIG. 6, the diagram displays an AMX device in a typical rack mounting, with
full air circulation around the front and back of the device. In this case, the main
concern is with heat building up between components, possibly to levels that
may affect device operation.
Heat convection in rack-mounted devices
FIG. 6
Installation Recommendations
During any installation, a lack of ventilation may produce conditions that may
adversely affect the device's operation. In these circumstances, special care
must be made to make sure that temperatures within enclosed areas do not
exceed the device's maximum rated temperature.
93-5968-70 REV: B