Extron electronics Matrix 3200 Series User Manual page 10

im Vertrieb von
Figure 2-1. An FPC 1000 mounted in a Matrix 3200/6400 Series Switcher BME
Installing the FPC 1000
_________ High voltage is present on the back of the FPC panel as well as inside the BME.
www.camboard.de
2-1
CAMBOARD Electronics
Installation • FPC 1000 Front Panel Controller • Chapter 2
The FPC 1000 offers local control at the switcher because it mounts as a front
panel on the master BME (Basic Module Enclosure), as shown in Figure 2-1. In a
system with more than one BME, the FPC 1000 must be installed in the master
unit (address 0).
If the FPC 1000 was ordered with the Matrix 3200/6400 Series system, it will
already be mounted. If it is being added, or changed, use the following
procedure, together with the illustrations on Page 2-2. All that is needed to install
the FPC 1000 is the RJ cable assembly that comes with the unit. If installing the
FPC 1000 in an existing system, it will replace the blank front panel in BME #0.
Remove power from the Matrix 3200/6400 Series system by turning the
power switch OFF and unplug the AC power cord.
Use a flat screwdriver or a thin coin to turn the two quarter-turn fasteners on
the blank front panel counterclockwise to release the panel. (Figure 2-2a)
Tilt the panel slightly out at the top and lift it up to free the tabs that hold the
bottom to the BME enclosure. These may be snug. Set the blank front panel
aside.
Inside the BME, locate the RJ connector on the main controller board
mounted on the floor of the enclosure.
Plug one end of the RJ cable that came with the FPC 1000 into the female
connector on the main controller board and the other to the connector on the
FPC 1000 board. (It doesn't matter which end.)
Place the FPC 1000 in front of the BME opening and align the FPC 1000 tabs
with the bottom edge in the enclosure.
Drop (press) the panel down and inward to fit into opening. The metal tabs
should fit snugly.
Use a flat screwdriver or a thin coin to turn the two quarter-turn fasteners on
the FPC 1000 clockwise to secure it in place.
Tel. 07131 911201
Matrix 3200/6400 Series Switchers • FPC 1000 • User's Manual • Extron
Fax 07131 911203
ce-info@camboard.de