Power Supplies - IBM Power System 8335-GTW Manual

Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Insert the replacement PCIe adapter into the system backplane as shown in Figure 99 on page 110,
aligning the adapter properly and inserting it fully into the slot.
Figure 99. Inserting a PCIe adapter
3. Using your labels, replace any plugs that you removed from the PCIe adapter. Using your labels, insert
the cables into the PCIe adapter.
What to do next
Prepare the system for operation. For instructions, see "Preparing the 8335-GTC, 8335-GTG, 8335-GTH,
8335-GTW, or 8335-GTX system for operation after you remove and replace internal parts" on page 202.
Removing and replacing a power supply in the 8335-GTC, 8335-GTG, 8335-
GTH, 8335-GTW, or 8335-GTX system
Find information about removing and replacing power supplies in the IBM Power System AC922 (8335-
GTC, 8335-GTG, and 8335-GTH) or IBM Power System AC922 (8335-GTW and 8335-GTX) system.
110 Power Systems: Servicing the 8335-GTW