Raymarine ST60 Tridata Instrument Owner's Handbook Manual page 33

81040_5.book Page 21 Monday, February 20, 2006 2:39 PM
Chapter 3: Installation
Fitting the low profile bezel
Flush mounting procedure
Flush mount your instrument (see the
1. Assemble the ST60 instrument and low-profile bezel as described under
ting the low-profile bezel
2. Ensure that:
• The panel on which you intend to mount the instrument is between 3 mm
• The selected location is clean, smooth and flat.
• There is sufficient space behind the selected location to accommodate the
3. Apply the flush mount template (supplied at the rear of this handbook) to
4. Cut out the aperture (3) for the assembled instrument and bezel and
5. Peel off the protective sheet from the self-adhesive gasket (4) then stick
.
and 20 mm thickness.
rear of the instrument and connectors.
the selected location and mark out the aperture into which the assembled
instrument and bezel will sit.
remove the template.
the gasket into position on the rear of the bezel.
8 7
Flush mounting
illustration) as follows:
21
9
D4362-2
Fit-