Procedures; Unpacking; Fitting The Instrument; Surface Mounting - Raymarine ST60 Tridata Instrument Owner's Handbook Manual

81040_5.book Page 18 Monday, February 20, 2006 2:39 PM
18

3.2 Procedures

As it is not possible to describe procedures for all possible installation scenarios,
the procedures given here describe the broad requirements for installing the
Speed and Depth transducers and the ST60 Tridata instrument. Adapt these
procedures as appropriate, to suit your individual requirement.
CAUTION:
Where it is necessary to cut holes (e.g. for cable routing and
instrument mounting), ensure that these will not cause a hazard
by weakening critical parts of the vessel's structure.

Unpacking

Unpack your ST60 equipment and check that the items described in
are present.
Each ST60 instrument is supplied with a standard bezel for surface mounting.
Optional mounting kits are available for flush mounting and bracket mounting
the instrument. If you have ordered the flush mounting option a low-profile bezel
and four fixing screws are also provided.

Fitting the instrument

The ST60 Tridata instrument can be installed using one of a number of different
mounting options:
• Surface mounting. Gives a profile of approximately 24 mm.
• Flush mounting. Gives a profile of approximately 6 mm.
• Bracket mounting.
The ST60 instruments can also be mounted behind a panel with just the
instrument dial and keys visible.

Surface mounting

To surface mount your ST60 instrument (see the
1. Ensure that:
• The selected location is clean, smooth and flat.
• There is sufficient space behind the selected location to accommodate the
rear of the instrument and connectors.
ST60 Tridata Instrument Owner's Manual
Surface mounting
Introduction
illustration):