Water Temperature; Timers - Raymarine ST60 Tridata Instrument Owner's Handbook Manual

81040_5.book Page 6 Monday, February 20, 2006 2:39 PM
6
The trip value is reset automatically at power-up, and if the instrument is
operating as a master, the trip value can also be reset manually by pressing the
reset key for 3 seconds.

Water temperature

The water temperature is shown in either degrees Celsius (°C) or Fahrenheit (°F),
as set during calibration (see

Timers

The count-up timer and to the two race-start timer times are either in seconds (S)
or minutes (M), depending on the counter values.
Using the trip key
Refer to the
you have done this, press the reset key to start the timer running. When a timer
is running, the delimiter (i.e. '.'or ':') flashes. For lap timing, press the reset key. To
stop and reset a timer to the start value, hold down the reset key for 1 second.
Once a timer is running, you can leave the timer page and select any other display.
The counter will continue to run in the background.
Race-start timers
You can set each race-start timer to any whole-minute value from 1 to 15 minutes.
Note: When the instrument is first installed, the race-start timers are set to 4 and 5 min-
utes respectively.
To set a race-start timer:
1. Use the trip key as shown in the
required race-start timer.
2. Simultaneously press the trip and reset keys to enter the race-start
timer adjust mode.
3. Use either the trip or reset key to set the required value.
4. Simultaneously press the trip and reset keys to save the value and leave
the race-start timer adjust mode.
If you are using one of the race-start timers and the timer buzzer is enabled, the
buzzer will:
• Double-beep every minute.
• Beep three times at the start of the last 30 seconds.
• Beep once for each of the last 10 seconds.
• Beep for 2 seconds at zero.
The timer buzzer is enabled or disabled as part of the calibration procedure (see
Chapter 4, Calibration
ST60 Tridata Instrument Owner's Manual
Chapter 4, Calibration
flow diagram to display the required timer. Once
Using trip key
).
).
flow diagram to select the