There are two possible points to pass the power-supply and accessory-control cables through: either on the anchoring base
through the existing slots (option 1), or on the end cap which features pre-shaped apertures (option 2).
Connect the ground to both gearmotors.
-
-
Option 1
Option 2
LEFT
HAND MOTOR
RIGHT
HAND MOTOR
Command and control devices
RSE card
The AF and RSE cards must be fitted
into the control board AFTER CUTTING
OFF THE MAINS POWER.
N.B.: the basic control board recognises
them only when it is powered up.
AF card
CRP - Came Remote Protocoll.
Connection to the home-automation
system.
OPEN-STOP function (NO contact)
CLOSE-STOP function (NO contact)
⚠ If the PARTIAL OPENING function is activated via a dip-switch on the button connected to 2-3, then the button connected
to 2-4 will automatically operate as a sequential OPEN-STOP-CLOSE-STOP command.
⚠ If MAINTAINED ACTION is activated via dip-switches, the two buttons will operate as automatically OPEN and CLOSE,
respectively.
⚠ When the MAINTAINED ACTION function is active, the PARTIAL OPENING function cannot be set.