Maintenance - Simons Voss Technologies RouterNode 2 Quick Manual

7. Maintenance

7 Maintenance
44 / 184
NOTE
Measurement errors due to structural changes
Structural changes and other wireless devices influ-
ence the WaveNet wireless network. If the WaveNet
radio network is measured before other components
are installed, the measurement results may sub-
sequently be falsified.
1. Do not carry out measurements in the unfinished
building, but in the finished condition (including po-
tential sources of interference).
2. If in doubt, plan for reserves.
If you want to operate the devices safely, you should at
least measure the following signal strengths:
First measurement: 70% to 100%.

Second measurement: 80% to 100%.

The device itself is maintenance-free. However, the
performance of radio networks will always depend on
environmental influences. These influences can
change and affect the performance of your radio
network. You should therefore check the network
configuration and performance of your radio network
at regular intervals.
RouterNode 2, GatewayNode 2,
SmartBridge
EN