Disabling Function - TECHFASS MREM 82 MTM-MF User Manual

•
– user cannot repeatedly use his ID for defined time
Time APB
•
– user cannot repeatedly enter an area, where he is already present
Zone APB
The Antipassback function is used
schedule. The users with access always granted are not affected by the Antipassback
function.
The Antipassback flags for an
programming cards
access rights data are downloaded
Both Zone and Time Antipassback flags are written either immediately
or after relevant door is opened
6.9.1 Time Antipassback
The Time Antipassback
the ID after passing at the reader module. If the users uses the ID at the address during the
timer for the ID is running, the Time APB alarm is raised. Following parameters affect the
Time APB function:
•
APB timer initial value
passing at the reader module. If a user uses the ID again before the timer elapses,
Time APB alarm is raised.
•
Open door after APB time alarm
performed after the Time APB alarm is raised.
6.9.2 Zone Antipassback
The Zone Antipassback
Zone APB flag is set for the ID when passing at the reader module. If a user uses the ID
again when the Zone APB flag is set, the Zone APB alarm is raised. Following parameters
affect the Zone APB function:
•
– enable/disable general Zone APB flag setting.
Enabled
•
Enable in offline mode
like if the APB function was not implemented.
•
Open door after APB Zone alarm
performed after the Zone APB alarm is raised.
6.10

Disabling function

This function is implemented since the FW version 5.08.
The module disabling function
configurable. The module behavior is as described below when the disabling function is
active:
•
User with access driven by a time schedule cannot run the door open function
•
User with access always granted is not affected by the disabling function
•
Remote door open function cannot be performed
•
Remote identification with ID is disabled for users with access driven by a time
schedule
only for the
ID can be
(offline solution). All Antipassback flags
from the program.
(relevant input is disconnected).
is defined by the
– defines the Time APB flag (timer) value set to the ID after
– if the option is enabled, the Door open function is
is defined by enabling the option
– if the option is not set, the module operates in offline mode
– if the option is enabled, the Door open function is
can be set at the second input. The logic of the function is
Page 20
users, whose access is driven by a
reset by inserting the ID again
are also
ABP timer initial value
for the relevant address. The
with use of the
reset whenever new
after an ID is
(in minutes), which is set to
time
read,