Table of Contents
Advertisement
6.10.2 Zone Antipassback
The
Zone Antipassback
Zone APB flag is set for the ID when passing at the reader module. If a user uses the ID
again when the Zone APB flag is set, the Zone APB alarm is raised. Following parameters
affect the Zone APB function:
Enabled
– enable/disable general Zone APB flag setting.
Enable in offline mode
like if the APB function was not implemented.
Open door after APB Zone alarm
performed after the Zone APB alarm is raised.
Set opposite APB flag after APB alarm
APB alarm flag is set for both directions (entry reader and the module itself) of the
module.
Clear opposite APB flag
causes a reset of the Zone APB alarm flag at the opposite direction.
6.11
Disabling function
This function is implemented since the FW version 5.08.
The
module disabling function
port. The logic of the function is individually configurable. The function is active whenever
one or both of the configured inputs are active.
The module behavior is as described below when the disabling function is active:
User with access driven by a time schedule cannot run the door open function
User with access always granted is not affected by the disabling function
Remote door open function cannot be performed
Remote identification with ID is disabled for users with access driven by a time
schedule
The disabling status changes and disabled actions are logged in the events archive.
6.12
Reading synchronization
Since the
FW version 5.09
is implemented, enabling to
module offers to use the
input/output port 3
is used as the
6.13
Online authorization
Since the
FW version 5.11
system. When the feature is used, the ID validity is resolved in connected PC. To be able
to use this authorization mode, the reader module has to be equipped with a
is defined by
enabling the option
– if the option is not set, the module operates in offline mode
– if the option is enabled, the Door open function is
– if the Zone APB alarm is raised, the Zone
– if the option is enabled, passing at the reader module
can be set at the second input and at the third input / output
the reading synchronization of a
cancel the mutual disturbance
IO synchronization
synchronization
the
Online authorization of ID
Page 18
for the relevant address. The
couple of TECHFASS readers
of the modules. The reader
in both
MASTER
and
signal.
can be used in APS mini Plus
SLAVE
mode. The
MLO
license.
Advertisement
Table of Contents
