Installation; Set Up And Operation; Dmx Address Mode - SHOWTEC Single MKII User Manual

Installation

Remove all packing materials from the
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Plug in the appropriate power outlet, this unit recovers to the function state of last time automatically by
reasons of power failure memory. And the Segment Display shows the DMX address of last change.
The Single-MK2 serves as a dimmer pack or a switch pack, depending on the operating mode to be
selected.

DMX Address Mode

1. When the unit is powered on, the Segment Display will show the DMX address of last change. And for
example, if you have selected DMX address 123 for the last time, the Segment Display will read 123.
2. Each tap upon the UP or DOWN button will change the DMX address once.
Pressing and holding down each button will change the DMX address quickly. Once the DMX address
has been selected, it will be stored into memory automatically.
( Relevant DMX address can be adjusted within the range of 001~512 )
www.liveline.be
Single MKII. Check that all foam and plastic padding is removed.
www.liveline.be
5