Sony HT-G700 Operating Instructions Manual page 46

C:\FY20HT_models\SB1\ANKI\UC2\01US-HTZ9FUC2\100TBS.fm
010COV.book Page 46 Wednesday, September 18, 2019 1:58 PM
TV remote control does not work.
 This problem might be solved by
setting [SYSTEM] - [IR REPEATER] to
[ON] (page 37).
Others
The Control for HDMI function does
not work properly.
 Check the connection with the
system (refer to the supplied Startup
Guide).
 Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
 Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be made.
Wait for 15 seconds or longer, and
then try again.
 Make sure the devices connected to
the system support the Control for
HDMI function.
 Enable the Control for HDMI function
on the devices connected to the
system. For details, refer to the
operating instructions of your device.
 The type and number of devices that
can be controlled by the Control for
HDMI function is restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to
3 devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphones): up to 1 device (used
by the system)
[PROTECT] flashes in the front panel
display and the system is turned
off.
 Disconnect the AC power cord (mains
lead) and make sure nothing is
46
US
obstructing the ventilation holes of
the system.
Sensors of the TV do not work
properly.
 The system may block some sensors
(such as the brightness sensor), the
remote control receiver of your TV or
the emitter for 3D glasses (infrared
transmission) of a 3D TV that supports
the infrared 3D glass system, or
wireless communication. Move the
system away from the TV within a
range that allows those parts to
operate properly. For the locations of
the sensors and remote control
receiver, refer to the operating
instructions supplied with the TV.
Wireless function (the BLUETOOTH
function or subwoofer) is unstable.
 Do not place metal objects other than
a TV around the system.
Music that you are not familiar with
suddenly plays.
 The pre-installed sample music may
have been played. Press
bar speaker to stop playback.
The system does not work properly.
 The system may be in demo mode. To
cancel demo mode, reset the system.
Press and hold  (power) and –
(volume) on the bar speaker for more
than 5 seconds (page 47).
masterpage: Left
on the
HT-G700
5-013-058-11(1)