Sony HT-G700 Operating Instructions Manual page 3

Hide thumbs Also See for HT-G700:
Table of Contents

Advertisement

C:\FY20HT_models\SB1\ANKI\UC2\01US-HTZ9FUC2\020REG.fm
010COV.book Page 3 Wednesday, September 18, 2019 1:58 PM
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
system and receiver.
– Connect the system into an outlet on
a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
Properly shielded and grounded cables
and connectors must be used for
connection to host computers and/or
peripherals in order to meet FCC
emission limits.
If you have any questions about this
Sound Bar:
Visit: www.sony.com/support
Contact: Sony Customer Information
Service Center at 1-800-222-SONY
(7669)
Write: Sony Customer Information
Service Center 12451 Gateway Blvd., Fort
Myers, FL 33913
Supplier's Declaration of Conformity
Trade Name: SONY
Model No.: HT-G700
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego,
CA 92127 USA
Telephone No.: 858-942-2230
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.
CAUTION
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this system.
This system must not be co-located or
operated in conjunction with any other
antenna or transmitter.
This system complies with FCC radiation
exposure limits set forth for an
uncontrolled environment and meets
the FCC radio frequency (RF) Exposure
Guidelines. This system should be
installed and operated keeping the
radiator at least 20cm or more away
from person's body.
For the customers in Canada
Properly shielded and grounded cables
and connectors must be used for
connection to host computers and/or
peripherals.
This system contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada's license-exempt
RSS(s). Operation is subject to the
following two conditions:
(1) This system may not cause
interference; and
(2) This system must accept any
interference, including interference
that may cause undesired operation
of the system.
This system complies with ISED
radiation exposure limits set forth for an
uncontrolled environment and meets
RSS-102 of the ISED radio frequency (RF)
Exposure rules. This system should be
installed and operated keeping the
radiator at least 20cm or more away
from person's body.
masterpage:
Right
US
3
US
HT-G700
5-013-058-11(1)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents