Configuring Ipv4 Settings; Dhcpv4 Configuration Setting; Static Ipv4 Address Configuration Settings; Ipv4 Dns Configuration Settings - HPE Edgeline EL8000 Setup And Configuration Manual

Configuring IPv4 settings

Prerequisites
Edgeline EL8000 Chassis Manager Admin privilege
Procedure
1. Click Network in the navigation tree, and then click the IPV4 tab.
2. Configure the DHCPv4 Configuration setting.
3. Configure the IPv4 Address Configuration settings.
4. Configure the DNS Configuration settings.
5. To save the changes you made on the IPv4 Settings page, click Apply.
6. When you are finished configuring the Edgeline EL8000 Chassis Manager network settings on the Network tabs, restart
the Edgeline EL8000 Chassis Manager system.
It might take several minutes before you can re-establish a connection.

DHCPv4 Configuration setting

The DHCPv4 setting is enabled by default.
Enable DHCPv4
Enables Edgeline EL8000 Chassis Manager to obtain an IP address (and other network specific address settings) from a
DHCP server.
NOTE: When DHCPv4 is enabled, the IPv4 Address Configuration section and DNS Configuration section are
automatically assigned. When the system is rebooted, these automatic assignments might change.

Static IPv4 Address Configuration settings

IPv4 Address
The Edgeline EL8000 Chassis Manager IP address. The IP address is supplied automatically when DHCP is enabled. When
DHCP is not enabled, enter a static IP address.
IPv4 Subnet Mask
The subnet mask of the IP network. The subnet mask is supplied automatically when DHCP is enabled. When DHCP is not
enabled, enter a subnet mask for the network.
IPv4 Gateway
The Edgeline EL8000 Chassis Manager gateway IP address. The Edgeline EL8000 Chassis Manager gateway IP address is
supplied automatically when DHCP is enabled. When DHCP is not enabled, enter an IP address for the gateway.

IPv4 DNS Configuration settings

Primary DNS Server
This value is supplied automatically when DHCP is enabled. If you are using a static IP address, no name servers are used.
Secondary DNS Server
This value is supplied automatically when DHCP is enabled. If you are using a static IP address, no name servers are used.
30 Configuration