Viewing The Network Configuration Summary; Network Configuration Summary Details; Ipv4 Summary Details; Ipv6 Summary Details - HPE Edgeline EL8000 Setup And Configuration Manual

Converged edge system
Table of Contents

Advertisement

To access the network settings, view or edit the network settings on the following pages:
Summary
General
IPv4
IPv6

Viewing the network configuration summary

Procedure
Click Network in the navigation tree.
The Summary tab is displayed.

Network configuration summary details

Name—The name of the active Edgeline EL8000 Chassis Manager network interface.
Host Name—The name assigned to the Edgeline EL8000 Chassis Manager subsystem. By default, the host name is
EL8000CM, followed by the system serial number. This value is used for the network name and must be unique.
NOTE: You can configure the Edgeline EL8000 Chassis Manager host name on the General tab.
MAC Address—The MAC address of the Edgeline EL8000 Chassis Manager network interface.
Permanent MAC Address—The unchangeable MAC address of the Edgeline EL8000 Chassis Manager network interface.
FQDN—The fully qualified domain name of the system.
IPv6 Default Gateway—When IPv6 is enabled, the gateway is the default IP address Edgeline EL8000 Chassis Manager
uses to access the network. When not enabled, this entry is blank.
Speed (Mbps)—The speed of the wired network, measured in megabits per second.

IPv4 Summary details

Address—The IPv4 address currently in use. If the value is 0.0.0.0, the IPv4 address is not configured.
Address Origin—Indicates whether the address was supplied automatically by DHCP or is static.
Gateway—The gateway address in use for the IPv4 protocol. If the value is 0.0.0.0, the gateway is not configured.
Subnet Mask—The subnet mask of the IPv4 address currently in use. If the value is 0.0.0.0, no address is configured.

IPv6 Summary details

Address—The IPv6 address currently in use. If the value is blank, the IPv6 address is not configured.
Address State—Indicates whether the address was supplied automatically or is static.
Gateway—The gateway address in use for the IPv6 protocol. If the value is blank, the gateway is not configured.
Prefix Length—The subnet mask of the IPv6 address currently in use.
28
Configuration

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents