Manual Entry - Wireless Access Point - GE Everest XLG3 VideoProbe Operating Manual

User Manual

Manual Entry - Wireless Access Point

The Manual Entry tab is used to enter network information that is either for "hidden "
networks (non-broadcast of wireless name (SSIS)), or to enter networks that are not
presently available.
1. To create a manual entry, select the Manual Entry tab, as shown below.
2. Under SSID, enter the name of the local access point (SSID). If a pass key is required
for security, select your appropriate security format (WEP or WPA). Select None when
no security encryption is used.
3. Selecting WPA encryption will require you to define encryption type as AES or TKIP.
Contact your local network administrator to define this information.
4. When WEP or WPA are selected, the appropriate entry field will be enabled. Next,
select Save or Save and Make Default.
5. Return to the Setup Menu > Communications, select Automatic. A check mark will
appear next to Automatic.
6. Exit out of the Communications Menu by selecting the Back button. Wait
approximately 20 seconds and then return to the Setup Menu > Communications
and an IP address should now be present.
For FireFox browser access, see Using the Desktop (page 78).
Chapter 3 Setting Up and Putting Away the System 37