Table of Contents
Advertisement
18
Chapter 1 Introduction
General Warnings
The following warning statements apply to use of the system in general. Warning
statements that apply specifically to particular procedures appear in the corresponding
sections of the manual.
WARNING ELECTRICAL SHOCK HAZARD — PROPER GROUNDING
REQUIRED. For procedures, see
WARNING DANGEROUS VOLTAGE. The outer panels of the base unit should
never be removed. Electrical shock hazard exists due to high internal voltage.
There are no user serviceable parts inside the base unit, except for the lamp and
fuses, which are accessible through the bottom and side panels, respectively.
Refer all service to listed service centers.
WARNING DANGEROUS VOLTAGE. Because the insertion tube is conductive,
and is connected to the base unit chassis and ground lug, do not allow the system
or its working tools to come in direct contact with any voltage or current source.
Prevent all contact with live electrical conductors or terminals. Damage to the
equipment and/or electrical shock to the operator may result.
WARNING LAMP EMITS ULTRAVIOLET, INFRARED, AND INTENSE VISIBLE
LIGHT. To prevent skin or eye injury, follow these instructions:
•
Avoid looking at or touching the lamp and fiber bundle output while light is on.
•
Do not operate the system when the handset is disconnected from the base
unit.
WARNING POSSIBLE EXPLOSION HAZARD. Do not use this system in
explosive environments.
WARNING USE PROPERLY. Using of any piece of this equipment in a manner
not specified by the manufacturer may impair the product's ability to protect the
user from harm.
GE Inspection Technologies XLG3 VideoProbe System
"Safe Powering and Grounding"
on page 23.
Advertisement
Table of Contents
Troubleshooting
