GE Everest XLG3 VideoProbe Operating Manual page 36

28 Chapter 3 Setting Up and Putting Away the System
7. Remove the insertion tube.
8. Attach the handset to the handle.
a. Slide the handset holder into either of the sockets. (There are sockets on both
b. Unwrap handset cable and remove handset. Slide handset into the holder,
c. Lock the swivel ball in position. (The lock holds the handset firmly in position while
9. Install the desired optical tip. Then snap probe end into the clip near the handset.
See
sides of the handle.) The holder clicks into place.
aligning the grooves in the back of the handset with the holder. Swivel the holder
into the desired position.
still letting you turn it from side to side.)
a
"Changing the Optical Tip"
GE Inspection Technologies XLG3 VideoProbe System
b
on page 31.
c