6.2Mm Internal Working Channel Feature - GE Everest XLG3 VideoProbe Operating Manual

150 Appendix F Optical Tips

6.2mm Internal Working Channel Feature

The internal working channel is available in the 6.2mm tip models. This channel has a
1.6mm ID and allows the use of micro-tools together with forward-viewing optical tips to
perform a number of measurement and retrieval tasks.
The tools are designed to be installed from a specified end of the probe, depending on the
particular tool. The following interchangeable tools, as shown below, are available for
6.2mm probes:
a. 4mm and 8mm magnetic retrieval tools
b. 3-prong gripper
c. hook tool
d. 0.055 inch comparitor gauge
e. small alligator
f.
g. loop/snare
h. brush
i.
large alligator
shim
a b c
GE Inspection Technologies XLG3 VideoProbe System
d e f g h i