Cleanliness; Cooling System - H3C MSR2600-6-X1-GL Installation Manual

•
Lasting low relative humidity can cause washer contraction and ESD and cause problems
including loose mounting screws and circuit failure.
•
High temperature can accelerate the aging of insulation materials and significantly lower the
reliability and lifespan of the router.
Table 2 Temperature and humidity requirements
Temperature
Operating temperature: 0°C to 45°C (32°F to 113°F)
Storage temperature: –40°C to +70°C (–40°F to +158°F)

Cleanliness

Dust buildup on the chassis might result in electrostatic adsorption, which causes poor contact of
metal components and contact points, especially when indoor relative humidity is low. In the worst
case, electrostatic adsorption can cause communication failure.
Table 3 Dust concentration limit in the equipment room
Substance
Dust particles
NOTE:
Dust diameter ≥ 5 µm
The equipment room must also meet limits on salts, acids, and sulfides to eliminate corrosion and
premature aging of components, as shown in
Table 4 Harmful gas limits in an equipment room
Gas
SO
2
H S
2
NH
3
NO
2
Cl
2

Cooling system

The router uses left-to-right airflow for heat dissipation, as shown in
Humidity
5% RH to 95% RH, noncondensing
Concentration limit (particles/m
4
≤ 3 x 10
(No visible dust on the tabletop in three days)
Table 4.
Maximum concentration (mg/m
0.2
0.006
0.05
0.04
0.01
2
3
)
3
)
Figure 1.