Connection From Navigation Device; Device To Helmet; To Helmet - BMW Motorrad Communication system Operating Instructions Manual

Briefly press button 2 to re-
ject an incoming call during the
sound signal.
Press button 2 briefly to hold
the current call.
Briefly press button 2 again to
resume the held call.
Press button 2 for a longer
period (approx. two seconds)
to end the current call.
NOTICE
For technical reasons, a brief
period might elapse after the but-
ton is pressed before the tele-
phone actually terminates the
call.
Connection from
navigation device to
helmet
Connection setup
Each helmet with a communica-
tion system can be paired with a
navigation device of its own, but
a navigation device can be paired
with only one helmet.
The configuration settings and
range of functions supported by
the navigation device determ-
ine whether or not connection
set-up between the communic-
ation system and the device can
take place automatically. Always
refer to the instructions for use of
the device in question for details.
Note that the Bluetooth function
must be active; the communic-
ation system might have to be
authorised or authenticated.
NOTICE
Before the initial connection
setup, the participating Bluetooth
devices must be made known to
each other (pairing).
Music playback is interrupted
for navigation announcements.
When using BMW Motorrad nav-
igation devices, communication is
still possible from helmet to hel-
met, whereas this is interrupted
with other navigation devices. An
acoustic alert sounds in the pas-
senger's helmet to indicate that
communication has been inter-
2
17
z