Connection From Helmet To; Helmet - BMW Motorrad Communication system Operating Instructions Manual

Press button 1 to cancel voice
control.
Connection from
helmet to helmet
Connection setup
The connection setup between
two helmets is automatic as soon
as both communication systems
are switched on.
NOTICE
Before the initial connection
setup, the participating Bluetooth
devices must be made known to
each other (pairing).
The communication between
helmets is interrupted during
phone calls or navigation an-
nouncements, this being indic-
ated by a sound signal in the
other helmet. Communication
between the two helmets is re-
stored, or music playback re-
sumed, as applicable, as soon as
the phone call or announcement
is over. The re-establishment of
the connection is indicated by a
new sound signal.
Exception: communication
between helmets is still possible
during navigation announcements
of BMW Motorrad navigation
devices.
Operation
Switch on the communication
systems of both helmets.
As soon as there is a connec-
tion between the helmets, the
green LEDs light up continu-
ously.
If no communication is possible:
Make sure that neither of the
helmets is in music mode.
Increase volume if required.
Check microphone alignment
( 12).
Briefly press button 2 twice
(change to music mode) to in-
terrupt the connection between
the helmets.
Briefly press button 2 twice
again to re-establish the con-
nection between the helmets.
2
15
z