Port Led State Indicators - Avaya 4900 Series Installing

Port LED state indicators

This section describes the port LED state indicators by color and fluctuation cues.
The following list describes the three port LEDs:
• Activity indicates the level of activity on the link.
• Link indicates the presence of an Ethernet link.
• Speed indicates the port speed (for example, 10 Mb/s, 100 Mb/s, 1000 Mb/s).
Table 17: RJ-45 Port LED state indicators
Label Color and Status
Speed/PoE Green, Pulse Green—
Green
Green, Steady
Amber, Pulse Amber—
Amber
Amber, Steady
Amber, Green Pulse
Off
Link / Activity Green, Steady
Green, Blink
Green, Slow Blink
Amber, Steady
Amber, Blink
Off
Table 18: SFP transceiver Port LED state indicators
Label Color and Status
In Use Green, Blink
Green, Steady
Amber, Blink
Amber, Steady
February 2016
Description
The port is set to operate at 1000 Mb/s and PoE is delivered on
the PoE model port.
The port is set to operate at 1000 Mb/s and no PoE power is
delivered on the port, on non-PoE or PoE models without a
PoE consumer attached to the port.
The port is set to operate at 100 Mb/s and PoE is delivered on
the PoE model ports.
The port is set to operate at 1000 Mb/s and no PoE power is
delivered on non-PoE switch ports or PoE switches without a
PoE consumer attached to the port.
The port is experiencing a PoE error.
When the Link/Activity LED is green and the Speed LED is off,
the port is set to operate at 10 Mb/s.
The link established but no data activity exists.
The link is established and data activity exists (the blink rate
indicates the level of activity).
The software disabled the port.
Port not used.
Not applicable.
The port has no link or activity.
Description
Not applicable.
The SFP port and the transmit port are active.
Not applicable.
SFP Installed—TX Port Inactive
Installing Avaya Ethernet Routing Switch 4900 Series
Comments on this document? infodev@avaya.com
Checking Light Emitting Diode on the switch
Table continues...
51