Section 6 - Samlexpower Evolution Series Owner's Manual

Inverter / charger pure sine wave
Hide thumbs Also See for Evolution Series:
Table of Contents

Advertisement

SECTION 5 |
!
CAUTION!
Ensure that charging voltage related parameters of EVO
(iii) FLOAT VOLTAGE and (iv) Temperature Compensation (COMPENSATE) are set / programmed to match
the programmed parameters of the external charge controller. [Please refer to (i) Table 6.2, Section 6 and (ii)
Sections 4.4.2.2 to 4.4.2.5 of the EVO-RC-PLUS Remote Control Manual].
!
ATTENTION!
S'assurer que la charge de tension, les paramètres connexes d'EVO
(ii) EQUALIZE VOLTAGE, (iii) Tension d'égaliser et (iv) La compensation de température (COMPENSATE) est
réglée / programmée pour correspondre aux paramètres programmés du contrôleur de charge externe.
[Veuillez consulter (i) le tableau 6.2, section 6 et (ii) les sections 4.4.2.2 à 4.4.2.5 du manuel d'utilisation de la
télécommande EVO-RC-PLUS].
5.5 BATTERY TEMPERATURE COMPENSATION USING TEMPERATURE SENSOR:
MODEL NO. EVO-BCTS
5.5.1 General Description – Battery Temperature Compensation
Please refer to Section 1.4.5 for general information on temperature compensation of battery charging voltages.
Battery Temperature Sensor Model EVO-BCTS [Fig 2.5(a)] has been provided to ensure optimum charging of Lead Acid
and Nickel Zinc (Ni-Zn) Batteries by negative temperature compensation of the charging voltages based on the battery
electrolyte temperature. The charging voltage is reduced when electrolyte temperature rises above the reference
temperature of 25°C / 77°F and increased when electrolyte temperature falls below the reference temperature of
25°C / 77°F.
i
INFO
Charging voltages of Lithium Ion Battery are not affected by temperature and hence, Battery Temperature
Sensor Model EVO-BCTS is not required to be used when Lithium Ion batteries are used.
Automatic temperature compensation will be carried out over temperature range of -20°C to +60°C based on the
programmed value of the negative "Temperature Coefficient of Battery Charging Voltage". In EVO, this parameter is
called "COMPENSATE" and is specified in "mV/C/Cell". For programming details of this parameter, please refer to the
following Sections of EVO-RC-PLUS Remote Manual:
94 | SAMLEX AMERICA INC.
Battery Charging in Evolution™ Series
like (i) ABSORP VOLTAGE, (ii) EQUALIZE VOLTAGE,
TM
comme (i) La tension d'absorption,
TM

Advertisement

Table of Contents
loading

Table of Contents