Servicing; Maintenance - Jøtul C 24 Installation And Operating Instructions Manual

ENGLISH
6.0 Service
Warning! Any unauthorised changes to the product are
illegal! Only original spare parts may be used!
6.1 Replacing the burn plates
Fig. 28
A
Fig. 29
A Ø10mm
1. Remove the side burn plates by lifting them slightly and
pulling out at the bottom (Fig 3).
2. Remove the screws (Fig 28A) and pull the back burn plate
out. Hold simutaneously the baffl e (Fig 28B) up so it does
not fall down. Please note that the seal on the back burn
plate needs to be replaced if damaged .
3. To install the burn plates, follow the same procedure in
reverse order
20
B A
B
6.2 Replacing the baffl e/exhaust
defl ector
1. First remove the side burn plates (Fig.3). It is not necessary
to remove the back burn plate .
2. Pull the baffl e (Fig. 28B) forward and down at the front
edge. Turn it so that it is standing diagonally behind the
front, and lift it out.
3. Lift the back edge of the exhaust defl ector (Fig. 30A), push
it backwards and then down at the front edge.
4. To install them, follow the same procedure in reverse
Fig. 30

7.0 Maintenance

7.1 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
fi replace during use. Soot is an insulator and will therefore
reduce the fi replace's heat output. If soot deposits accumulate
when using the product, they can easily be removed by using
a suitable detargent.
In order to prevent a layer of water and tar from forming in the
fi replace, you should regularly allow the fi re to burn hot in order
to remove the layer. Your product should be cleaned internally
once a year to ensure the best heating eff ect. It is a good idea
to do this when cleaning the chimney and fl ue pipes.
A
order.