Table of Contents
Advertisement
Note: The KA7171 front panel is similar to the KA7171AK, except that
it does not have the (no.1) PRIORITIZED CONTORL Port, and the
(no.2) RS-232 Serial Port.
3. Plug the USB or PS/2 connectors on the other end of the KVM
cable into the appropriate ports on the local computer.
Note: Plugging both the USB and PS/2 connectors into the computer at
the same time may cause the installation to malfunction.
4. Plug one end of the Cat 5e cable into the KA7171 / KA7171AK 's I/
O port. Plug the other end of the Cat 5e cable into the port of the
KVM switch.
5. Plug the PS/2 connector of the 2XRT-0015G to the purple Control
Port on the front panel of the KA7171AK.
Note: This step is only for KA7171AK that includes 2XRT-0015G KVM
over IP Access Control Box in the KA7171AK package. If your package
is KA7171, you can omit this step.
6. Plug the power adapter (supplied with this package) into an AC
source; plug the adapter's power cable into the KA7171 /
KA7171AK's Power Jack.
7. Power on the local PC.
Hot Plugging
KVM over IP console stations support hot plugging – components can
be removed and added back into the installation by unplugging and
replugging cables from the ports without the need to shut the unit down.
Chapter 2. Hardware Setup
11
Advertisement
Table of Contents
