Advertisement
Available languages
Available languages
Quick Links
HOLLYWOOD RACKS
Assembly and Installation instructions Model # HR520
WARNING! THIS PRODUCT IS NOT TO BE USED ON ANY TRAILER
PLEASE FOLLOW THESE IMPORTANT POINTS:
DRIVE SLOWLY WHEN USING THE RACK ON BUMPY OR DIRT ROADS.
CHECK THE RACK, BIKES AND STRAPS REGULARLY DURING USE.
IF YOU HAVE ANY QUESTIONS OR INSTALLATION PROBLEMS, PLEASE SEE YOUR
RETAILER OR CONTACT US AT 800 – 747- 4085.
Fig. 4:
Rubber strap: qty =15
Woven strap: qty = 5
(one attached to rack)
Road Runner 5 Bike Hitch Rack
Fig. 2
Qty = 2 each
Fig. 1
Fig. 5
1
2" class 3 hitch req'd
Fig. 6
Advertisement
Related Manuals for Hollywood Racks Road Runner 5 Bike Hitch Rack
Summary of Contents for Hollywood Racks Road Runner 5 Bike Hitch Rack
- Page 1 Road Runner 5 Bike Hitch Rack HOLLYWOOD RACKS Assembly and Installation instructions Model # HR520 2” class 3 hitch req’d WARNING! THIS PRODUCT IS NOT TO BE USED ON ANY TRAILER PLEASE FOLLOW THESE IMPORTANT POINTS: DRIVE SLOWLY WHEN USING THE RACK ON BUMPY OR DIRT ROADS.
- Page 2 After opening the box, you should have the following parts: - Upright beam assembly (Fig 1) with wheel brace installed - Two Support Arms (see Fig. 1) - Parts bag including ½” diameter bolt, washers and nut, lynch pin and clip (Fig. 2: A, B, C, D). - Locking hitch pin with security cable (Fig.
- Page 3 INSTALLING BIKES ON THE RACK: 7. Back off the knob on the rack’s support arms, pull out the support arms and rotate them into the horizontal position. The arms should fit into the welded steel channels. Retighten the knobs securely. Rotate lower brace to its horizontal position.
- Page 4 (at its option) a defective part or the complete rack without charge for labor or parts. Hollywood Racks may elect (at its option) to issue a refund equal to the purchase price paid for the product.
- Page 5 Hollywood Road Runner 5. Instructions d’assemblage et d’installation Modéle HR520 Attention! Ne jamais monter se produit sur une remorque ou un véhicule remorqué Suivre les directives suivantes: Conduire doucement sur chaussée en mauvais état ou chemin de terre. Vérifier le porte-vélo, les vélos et les sangles régulièrement pendant utilisation. Après avoir ouvert la boite, vous trouverez les pièces suivantes: - Poteau central (Fig 1) avec bras inferieur installé.
- Page 6 Installer les velos sur le porte-vélo. 1. Deserrer les mollettes de chaque côté des bras de supports, et faire pivoter les bras de supports dans une position horizontale ou d’utilisation dans les pièces soudées sur chaque côté. Reserrer les mollettes fermements. Dévisser la molette de la barre inferieure (Fig 6) et faire pivoter en position horizontale.