Download Print this page

Hollywood Racks Road Runner 5 Bike Hitch Rack Assembly And Installation Instructions Manual page 4

Advertisement

Available languages

Available languages

12. Installing "wrap around tie down," and security cable: After all the bikes have been installed, take
the 86" tie down strap and wrap it around the rack's upright tube and all of the bikes. There is not a lot
of room, but this is a very important safety step. Tighten this strap securely.
13. Anti –Theft Security
For anti-theft security, the rack comes with a locking hitch pin and a 9-foot cable with an integrated
lock. Wrap the cable around the bike frames, their wheels and through the rack. Secure by inserting
end of cable in the lock.
14. REMOVING THE BIKES AND RACK
To remove the bikes, simply undo the straps and gently lift the bikes off. If you're in a parking lot, be
sure to fold down the support arms and fold up the wheel brace so as to minimize the length of the
rack when not in use. To remove the rack from the vehicle, fold the support arms and lower brace,
and remove the Locking Hitch Pin. Unscrew (counter-clockwise) the "no wobble" lever and slide the
rack out of the hitch receiver.
15. BACKING OUT OF DRIVEWAYS
Please keep in mind that when transporting bikes, you will be carrying more weight on your hitch.
This means the rear of your vehicle will be lower to the ground. When going up driveways or over
bumps, drive slowly and at an angle if possible. If you have a car or minivan where the hitch is low to
the ground, the rack may hit the ground. Go slowly and please be sure the handle lever for the no
wobble system is turned up or to the side.
Limited Lifetime Warranty (effective January 1, 2008):
Hollywood Racks will warrant its car racks and accessories during the time that an original retail purchaser owns the
product subject to the exclusions and limitations of this warranty. Hollywood Racks will remedy defects in materials
and workmanship by repairing or replacing (at its option) a defective part or the complete rack without charge for labor
or parts. Hollywood Racks may elect (at its option) to issue a refund equal to the purchase price paid for the product.
This warranty does not cover problems caused by normal wear and tear including (but not limited to) weather,
scratches, dents, rust, accidents, unlawful vehicle operation, misuse, abuse, neglect, theft, unauthorized modifications,
or unauthorized repair. No warranty is given for defects resulting in incorrect assembly, incorrect installation onto the
vehicle, installation on a "no fit" vehicle, incorrect attachment of bicycles onto the rack, or overloading of the rack's
weight restrictions. This warranty terminates if the original retail purchaser transfers the product to any other person.
If a product is believed to be defective, the original retail purchaser should contact either the original retailer or
Hollywood Racks directly at 800-747-4085 or at info@hollywoodracks.com
Disclaimer of Liability: Repair or replacement of a defective product or the issuance of a refund or credit (as
determined by Hollywood Racks) is a purchaser's exclusive remedy under this warranty. Damage to a purchaser's
vehicle, cargo, bicycles and or to any other person is excluded. This warranty is expressly made in lieu of any and all
other express warranties, whether oral or written.
Hollywood Racks shall not be liable for any direct, indirect, consequential, incidental, special, punitive or any other
damages in connection with the purchase, use or handling of this product.
Some states do not allow the exclusion or limitation of consequential or incidental damages and the above limitation
may not apply to you. This warranty gives you specific legal rights and you have other rights, which vary from state to
state.
(800) 747-4085 or (310) 516-8600 FAX (310) 516-8955
Customer Service: M-F 8:00 AM – 3:00 PM PST
GOING OVER BUMPS
AND
Hollywood Racks
12812 S. Spring St. Los Angeles, CA 90061
www.hollywoodracks.com
info@hollywoodracks.com
Made in Taiwan
4
022008 rev c

Advertisement

loading

This manual is also suitable for:

Hr520