Advertisement
Quick Links
H
OLLYWOO
R
A
C
K
www.hollywoodracks.com
Assembly and Installation instructions for model numbers:
Road Runner 3 Series
HR300 - 3-bike model for 2" receiver, class 2 or higher
HR310 - 3 bike model for 1 ¼" receiver, class 2 (maximum weight of bikes 150 lbs.)
HR320 - 3-bike model extended for 2" receiver, class 3 or higher
Road Runner 4 Series
HR400 – 4-bike model for 2" receiver, class 2 or higher
HR410 – 4 bike model for 1 ¼" receiver, class 2 (maximum weight of bikes 150 lbs.)
HR420 – 4-bike model extended for 2" receiver, class 3 or higher
Destination 5
HR520 – 5-bike model 2" receiver, class 3 or higher
WARNING! THIS PRODUCT IS
PLEASE FOLLOW THESE IMPORTANT POINTS:
DRIVE SLOWLY WHEN USING THE RACK ON BUMPY OR DIRT ROADS.
CHECK THE RACK, BIKES AND STRAPS REGULARLY DURING USE.
IF YOU HAVE ANY QUESTIONS OR INSTALLATION PROBLEMS, PLEASE SEE YOUR
RETAILER OR CONTACT US AT 800 – 747- 4085.
Bike Cradle with strap
Support Arm
3
Lower brace
No Wobble lever
D
S
Anti-sway Block
2
Insert tube
Deluxe Trailer Hitch Rack
NOT
TO BE USED ON ANY TRAILER
1
Upright Beam
Receiver
1
Advertisement
Related Manuals for Hollywood Racks Road Runner 3 Series
Summary of Contents for Hollywood Racks Road Runner 3 Series
- Page 1 Assembly and Installation instructions for model numbers: Road Runner 3 Series HR300 - 3-bike model for 2” receiver, class 2 or higher HR310 - 3 bike model for 1 ¼” receiver, class 2 (maximum weight of bikes 150 lbs.) HR320 - 3-bike model extended for 2”...
- Page 2 Strap Qty: After opening the box, you should have the following parts: 3 Bike: 9 Rubber, 4 nylon 4 bike: 12 Rubber, 5 nylon 1. Upright beam assembly with upper support arms installed. 2. Insert tube assembly with “no wobble” system and handle lever. 5 bike: 15 rubber, 5 nylon 3.
- Page 3 INSTALLING THE RACK ON YOUR VEHICLE: 1. Within the parts bag, please locate the Locking Hitch Pin. See Photo above. 2. When inserting the rack into the trailer hitch, try to get the insert tube as parallel to the receiver hitch as possible, then slide the rack in a couple of inches until the welded on stop on the top of the insert tube meets the outer flange (face) of your vehicle’s receiver.
- Page 4 This warranty gives you specific legal rights and you have other rights, which vary from state to state. Hollywood Racks 12812 S spring St. Los Angeles, CA 90061...