Pairing The Wall Switch; Finding A Location For The Wall Switch - QuietCool GA ES-1500 Owner's Manual

3.3

Pairing the Wall Switch

1. Using a flat-head screwdriver, remove the front cover off the wall switch.
2. Install the included AAA batteries into the switch. All the LED indicators will light up indicating that the switch
has power. Replace the front cover.
3. Press and hold the Pair button on the Hub. The Pair LED indicator will be on for three seconds then turn off. This
clears all previous pairings out of the Hub,
4. Press the Pair button on the Hub twice. The Pair LED indicator will blink once every second indicating the Hub is
in pairing mode.
5. Press either one of the buttons on the Wall Switch to wake it up. Now hold one of the buttons on the switch.
The Pair LED indicator on the Hub will go out and the Wall Switch speed indicators will be blinking indicating
successful pairing. Press the Wall Switch button again, the speed indicators will go out, and it will display the
current fan status.
6. Press the Timer button to test the Wall Switch to make sure it is communicating with the Hub.
NOTE: If a button on the Wall Switch is not pressed within three minutes of pressing the Pair button
on the Hub, the LED indicator on the Hub will go out, indicating unsuccessful pairing. You will need to
go back and repeat steps 4 and 5.
3.4

Finding a Location for the Wall Switch

1. It is very important to find the correct location to install the Wall Switch that will allow the Wall Switch to
communicate with the Hub.
2. Find the location you would like to install the Wall Switch and test that it properly communicates with the fan
to turn the fan on and off.
3. If the fan comes on, this is a good location.
4. If all the LED indicators turn on, the Wall Switch is not communicating with the Hub and you will need to find a
location closer to the fan.
1-888-QUIETCOOL 7