Installation; Installing Ga Model Fans - QuietCool GA ES-1500 Owner's Manual

2. INSTALLATION

2.1 Installing GA (Garage Attic) model fans
VERY IMPORTANT:
GA MODEL FANS. ALWAYS FOLLOW LOCAL BUILDING CODES.
1. Determine in which area you would like to install your QuietCool Garage Attic Fan. Now it's time to find the
exact location using a stud finder or by going up into the attic and finding the location. Locate the ceiling
studs and mark the location for the fan to be installed. (see Figure 2.1A) One side of the cut out should be
directly next to a wood member for proper fan mounting and support. NOTE: You will need to remove the
ceiling flange from the side of the fan that will be mounted against the wood member.
2. When you find the location, mark a 14 1/4" square using a framing square or template. Make sure you have 2" of
clearance all the way around it. The grille that will be installed later is a 16" square. (see Figure 2.1B)
3. Starting at one corner of the square using a drywall saw, cut out the opening. Remove the drywall cutout and
clear away insulation (if applicable). (see Figure 2.1C)
4. Take the GA fan model into the attic and place it over the ceiling cut out. (see Figure 2.1D)
NOTE: This can be done through the attic access. If you don't have an attic access, you will need to
remove the ceiling flanges to fit the fan directly through the ceiling cutout.
5. Attach the fan using screws into the ceiling joists. (see Figure 2.1E). Install the ceiling grille. (see Figure
2.1F)
Figure 2.1A
Figure 2.1D
1-888-QUIETCOOL
MINIMUM OF 26" CLEARANCE REQUIRED ABOVE CEILING FOR INSTALLATION OF
Figure 2.1B
Figure 2.1E
Figure 2.1C
Figure 2.1F
3