Related Manuals for Clarke CPP2B
Summary of Contents for Clarke CPP2B
- Page 1 PRESSURISED PAINT CONTAINER MODEL NO: CPP2B PART NO: 3082115 OPERATION & MAINTENANCE INSTRUCTIONS GC0913...
- Page 2 INTRODUCTION Thank you for purchasing this CLARKE Pressurised Paint Container. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
-
Page 3: General Safety Rules
GENERAL SAFETY RULES Before using this equipment it is in your own interest to read and pay attention to the following safety rules. 1. Keep the work area clean. Cluttered areas invite injuries. Keep the work area well lit. 2. Keep children away. Children must never be allowed in the work area. 3. - Page 4 Only use the product for the purpose for which it is intended. 11. When replacing parts, only use those supplied by Clarke International as shown by the parts list on page 10.
-
Page 5: Product Overview
PRODUCT OVERVIEW DESCRIPTION DESCRIPTION Carrying / Support Handle Air Outlet Hose (orange) Air Pressure Gauge Paint Delivery Hose (black) Air Adjusting Screw Safety Valve Regulator Air Outlet Air Inlet Paint Shut-off Valve Vent Valve Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 6: Air Supply
6mm (¼”) ID and fittings should have the same internal dimensions. OPERATION This CPP2B paint container is designed primarily for spraying oil and solvent based paint. Clarke International provides a range of spray guns which may be used with this container. Please see examples on page 11. -
Page 7: Specification
5. Connect the paint hose (black) from the spray gun to the paint outlet. 6. Ensure the pressure regulator knob is turned fully anticlockwise, then turn on the air supply from your compressor/air supply to the paint container. 7. Turn the pressure regulator knob clockwise to pressurise the container until the required pressure is achieved. -
Page 8: Maintenance
MAINTENANCE It is essential to clean the equipment thoroughly after use. Dried paint in the outlet and the hoses will undermine the performance of the equipment. CLEANING PROCEDURE 1. Turn off the air supply to the container. 2. Open the air outlet valve. 3. -
Page 9: Parts Diagram
PARTS DIAGRAM Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 10: Parts List
PARTS LIST DESCRIPTION DESCRIPTION Handle 22 Socket Screws Adjusting Screw 23 Stopper Locking Nut 24 Air Adjusting Screw Spring 25 Locking Nut Valve 26 Air Regulator Body Valve Gasket 27 Spring Seat Valve Seat 28 Spring Connector 29 Sealing Nut Olive 30 Laminated Gasket 10 Connector... - Page 11 CLARKE SPRAY GUNS A wide variety of Clarke spray guns can be used with this pressurised paint container and are available from your local stockist. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...