Related Manuals for Clarke CHHSB1
Summary of Contents for Clarke CHHSB1
- Page 1 HAND HELD SODA BLASTER MODEL NO: CHHSB1 PART NO: 7640137 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC 06/23...
-
Page 2: Work Environment
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Transportation And Storage
2. DO NOT connect the air supply hose with your finger on the trigger. 3. DO NOT exceed the maximum pressure for the product. 4. Check hoses for leaks or worn condition before use and ensure that all connections are secure. 5. -
Page 4: Compressed Air Requirements
A wide range of airline accessories is available including filter/regulators, high- pressure hoses (5 to 50 metres) etc. Contact your CLARKE dealer for further information or CLARKE International Service Department. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 5: Before Use
BEFORE USE 1. Connect a suitable hose with a threaded connector to the air inlet. 2. Connect the other end of the hose to the compressor. 3. Run the compressor at low pressure and check for leaks. 4. Fill the container with dry soda blasting media. Wet or moist soda can clog the blaster and cause a malfunction. -
Page 6: Maintenance
7. When finished clean off soda dust e.g. with a blowgun or by vacuum cleaning. If your workpiece is to be painted after the blasting it is a good idea to clean it thoroughly before painting. 8. DO NOT disconnect the air supply hose until the compressor has been shut down and the compressed air released. -
Page 7: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 8 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...