Related Manuals for Clarke CTG8
Summary of Contents for Clarke CTG8
- Page 1 AIR TEXTURE GUN MODEL NO: CTG8 PART NO: 5091120 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0718 ISS 2...
- Page 2 The CTG8 Air Texture Gun is a high capacity unit designed for large surface coverage, handling most textured wall and ceiling finishes. It can spray most liquid dry wall materials from joint cement, ceiling acoustics, wall texture, splatter, semi-fog or any such material that will feed through the hopper.
-
Page 3: Specifications
SPECIFICATIONS Hopper Capacity 7.95 litre (1.75 gal) Weight 1.5 kg Air Inlet /Outlet Size 1/4“BSP (female) Nozzle sizes 1.5mm, 2.7mm,3.5mm & 3.6mm Air consumption 6-25 cfm GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase. -
Page 4: General Safety Precautions
GENERAL SAFETY PRECAUTIONS CAUTION: FAILURE TO FOLLOW THESE PRECAUTIONS COULD RESULT IN PERSONAL INJURY, AND/OR DAMAGE TO PROPERTY. WORK ENVIRONMENT 1. Keep the work area clean and tidy. 2. Dress appropriately - do not wear loose clothing or jewellery. Tie long hair out of the way. -
Page 5: Compressed Airline Requirements
9. Never use this product if it is defective/operating abnormally. 10. Never attempt any repairs yourself. If you have a problem with this product contact your local CLARKE dealer. COMPRESSED AIRLINE REQUIREMENTS WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF COMPRESSORS AND COMPRESSED AIR SUPPLY. -
Page 6: Operation
• If an unusually long air hose is required, (over 8 metres), the line pressure or the hose inside diameter may need to be increased. • The air hose must be rated at least 150% of the maximum operating pressure of the air tool. •... - Page 7 3. Loosen the securing block (34), and remove the orifice plate (31). Unscrew the nozzle (18) currently fitted and screw the chosen nozzle onto the end of the inlet tube (30), taking care not to lose the white rubber seal ring (42) from inside the nozzle.
-
Page 8: Maintenance
The following starting points are suggested. However, adjustment is partly trial and error, depending on the viscosity of the material and coverage required. Always take care that the paint material is free of lumps. Follow the manufacturers instructions when mixing materials. a When spraying acoustic panels, set the orifice plate to the third smallest size (5/16”) opening. - Page 9 More abrasive materials such as latex paint (emulsions) will cause these parts to wear much faster. Use only Clarke replacement parts, available from your nearest Clarke dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 10: Parts List And Diagram
A wide range of accessories is available including filter/regulators, lubricators, high-pressure hoses (5 to 50 metres) etc. Contact your CLARKE dealer for further information or CLARKE International Service Department. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 11: Parts Diagram
PARTS DIAGRAM Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...