Konica Minolta AIRe Lens User Manual page 55

3.11 Wireless LAN network settings
Reading a wireless LAN setup QR code
A wireless LAN network which this product will connect can be registered by reading a generated QR code.
Procedure
1
Start up the Wireless LAN Setup App on the Home Screen of this product.
2
Displays the camera image on the screen of this product.
3
Align the QR code that was previously generated with the camera image on the screen of this product.
% If the QR code from a display cannot be read, print out the QR code and try again.
4
When the QR code is read successfully and connection with the wireless LAN access point is achieved,
a screen as shown below is displayed.
*
The above IP address is for illustrative purposes only. The actual IP address displayed will depend on
the environment where the IP address was acquired.
Precautions
- The wireless LAN network information included in the QR code is registered on this product when read-
ing of the code completed.
- Only one wireless LAN network can be registered.
-
When configuring wireless LAN network settings using a QR code assigns an IP address to this product
by DHCP.
-
For information about how to set a device static IP address for this product, refer to page 3-34.
AIRe Lens
3
3-33