Clearaudio Statement TT1 User Manual page 8

Statement TT 1
User Manual
Now place the installation gauge (4) for the tonearm base on top of the two cylinders (3)
while all four pins on the bottom of the installation gauge, must fit into the threats machined
into the cylinders. You might have to turn the cylinders for correnty aligning.
4
3 3
Picture 5: Placing the installation gauge
4
3
3
Picture 6: Placing the installation gauge
Tighten the 2 bolts, with the provided hex key, while holding ( pressing ) the gauge down.
Attention: any misalignment will leat to a problem to place the TT1 tonearm later !
Picture 7: Tighten the gauge
Page 8  clearaudio electronic GmbH 2013