Assembly; Unpacking; Tools Needed; Assemble The Dust Chute - PowerTec BD1502 Owner's Manual

2

UNPACKING

Refer to Figure 1.
Check for shipping damage. Check immediately whether
all parts and accessories are included.
The sander comes assembled as one unit. Additional
parts which need to be fastened to sander, should be
located and accounted for before assembling.
2
ITEM DESCRIPTION
A Dust Chute (with dust nozzle adapter)
B Screw M4×10 (dust chute assembly)
C Spring washer (dust chute assembly)
D Sanding Disc Table
E Locking Knobs (sanding disc table)
F Washers (sanding disc table)
G Sanding Belt Table
H Locking Lever (Sanding Belt Table)
I Washer 8 mm (Sanding Belt Table)
J Miter Gauge
K Hex Wrench
L Operators Manual (not shown)
Figure 1
J
G
A
B
C
WARNING
Do not use the machine until it is completely assembled
and you have read and understood the entire
operating manual.

TOOLS NEEDED

The following tools (not included) are needed to assemble
and adjust the belt/disc sander:
• Combination square
• Phillips screwdriver
• Standard screwdriver
• 4 mm Hex Wrench
QUANTITY
D E
F
I H
K

ASSEMBLY

ASSEMBLE THE DUST CHUTE

Refer to Figure 2
• Slide the groove in the dust chute onto the sanding disc
guard casting as shown. Secure the dust chute to the
sander with screws, flat washers and spring washers
supplied. Ensure the dust chute opening faces the rear
of the unit.
Figure 2
1
3
3
1
2
2
1
1
1
1
1
1

ASSEMBLE THE SANDING DISC TABLE

Refer to Figure 3, 4
• Align the sanding disc table to the sanding disc guard
• Align the pins on the sanding disc table with slots on
the sanding disc guard. Slide the pins in and up into
the slot.
• Place a washer on each locking knob.
• While holding the sanding disc table in place, thread
a locking knob into the slot on each side of the table.
Tighten each locking knob.
Figure 3
Slot
Locking
Knob and
Washer
Hole for
Locking
Knob
Sanding Disc
Dust Chute
Flat
Washers
Washers
Screws
Sanding Disc
Guard
Sanding
Disc
Table
Pins
Groove