Assembly; Mounting The Sanding Belt Table - PowerTec BD1030 Owner's Manual

2
UNPACKING
Refer to Figure 1.
Check for shipping damage. Check immediately whether
all parts and accessories are included.
The sander comes assembled as one unit. Additional
parts which need to be fastened to sander, should be
located and accounted for before assembling.
2
ITEM DESCRIPTION
A Sanding Belt Table
B Locking Lever (Sanding Belt Table)
Figure 1
A
WARNING
Do not use the machine until it is completely assembled
and you have read and understood the entire operating
manual.
TOOLS NEEDED
The following tools (not included) are needed to assemble
and adjust the belt sander:
• Combination square
• Phillips screwdriver
• 3 mm Hex Wrench

MOUNTING THE SANDING BELT TABLE

Refer to Figure 2–5
• Remove the belt guard locking knob and then the side
belt guard.
Figure 2
Belt Guard
Locking
Knob

ASSEMBLY

QUANTITY
B
Side Belt
Guard
• Take apart the locking lever assembly (hex headed bolt,
washer, splined shaft, lever and screw with spring).
Figure 3
Hex
headed
Bolt
1
1
• Slide the sanding belt table into place with the adjusting
slot over the hex head bolt.
• Slide the washer onto hex head bolt.
• Thread the splined shaft onto the hex head bolt.
• Slide the lever onto the splined shaft until it stops.
• Insert spring with screw into lever and tighten until
screw head extends above the lever.
Figure 4
Sanding Belt
Table
Adjusting
Slot
• Tighten set screw. Adjust table before tightening the set
screw. See Adjust Sanding Belt Table.
Figure 5
Sanding Belt
Table
• Assemble the side belt guard and secure in place with
the belt guard locking knob. (Figure 2)
Washer
Lever
Screw and
Spring
Splined
Shaft
Hex
Head
Screw
Bolt
and
Spring
Splined
Washer
Shaft
Lever
Backstop
Sanding
Belt
Set
Screw
Locking
Lever