LG WD-3243RHD Owner's Manual page 20

÷ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical
shock to avoid electrical shock hazards.
• The water inlet filter
- No Inlet error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is a good idea to clean it from time to time.
1, Turn off the
water tap.
3, Cleanthe
filter using a
hard bristle
brush.
2. Unscrewthe
waterinlet
hose.
4. Tighten up
the inlet
hose.
• The drain pump filter
÷ The drainfiltercollects threadsandsmallobjectsleft in thelaundry.
Checkregularly thatthefilteris cleanto ensuresmoothrunningofyourmachine.
_, CAUTION Firstdrain it usingthe drain hoseand thenopen the pumpfilter to remove
whatever may havestoppedit up.
Be carefulwhen drainingif the water is hot.
1. Openthe lower cover
cap IN by using coin.
Turn the drain plug/_
to pullout the hose.
2. Unplugthe drain plug _, allowing
the waterto flow out.At this time
use a vessel to prevent water
flowing on to the floor. If the water
does not flow any more,turn the
pumpfilter _ open to the left.
3. Take out any foreign material
from the pump filter _. After
cleaning,turn the pump filter _
clockwiseand insertthe drain
plug _to the original place,
close the lower cover cap.