Connecting Your Printer To A Network; Direct Ethernet Connection To Macintosh Or Pc - Tektronix Phaser 850 Setup Manual

Connecting Your Printer to a Network

Direct Ethernet Connection to Macintosh or PC

Requirements
Two RJ-45, twisted-pair, 10Base-T cables
An Ethernet-port hub
Procedure
1.
Turn off your computer and the printer.
2.
Connect one end of an Ethernet cable to the Ethernet port on your computer. Connect
the other end to the hub.
3.
Connect the other cable to the hub and the Ethernet port on the printer.
Note
The printer is not a SCSI device. Do not connect the printer to your
computer through the SCSI ports.
4. Turn on your computer and printer.
After the computer and printer are connected, refer to the configuration instructions for
your network type.
Networking Setup Guide
Connecting Your Printer to a Network
3094-73
3