Setting Ipx Frame Types From The Phaser 850 Front Panel - Tektronix Phaser 850 Setup Manual

Job is serviced, but does not print
Check the PhaserShare Administrator Printer Info dialog box for reported error
conditions.
Download the PostScript Error Handler to the printer. For information on using the
Tektronix PostScript Error Handler, see your printer's user documentation.
Use the correct Tektronix driver for your printer.
Verify that the Print Server protocol is enabled; use the printer's front panel or check
the Administrator's Print Server tab.
Banners, form feeds, and tabs may interfere with the print job. Try disabling these.
Setting IPX frame types from the Phaser 850 front
panel
1.
When the front panel displays READY TO PRINT, press the up-arrow button until
Menu is highlighted. Press Select.
2.
Press the down-arrow button until Printer Configuration is highlighted. Press Select.
3.
Press the down-arrow button until Network Settings is highlighted. Press Select.
4.
Press the down-arrow button until NetWare is highlighted. Press Select.
5.
Press the down-arrow button until IPX Frame Type is highlighted. Press Select.
6.
Press the down-arrow button until the desired frame type is highlighted. Press Select
until On is displayed. If desired, you can set more than one frame type.
7.
To return the printer to normal operation, press the down-arrow button until Exit is
highlighted. Press Select.
Networking Setup Guide
Novell NetWare
13