Fleck 7000 Installation Manual page 6

1. Find the main line to your home to install the inlet and outlet. This is usually located on the same side of the
house as your water meter.
2. Once you have found the main line you need to cut it and install 2 90s.
3. Turn your water off at the meter or main shut off to the house. This has to be prior to where you are installing
the water softener
4. The first 90 will be the inlet to the water softener. You need sweat or glue this fitting.
5. Run the pipe (copper or pvc) up to the sweat copper fitting or pvc fitting The sweat fitting will require you use
another 90 to put into the copper fitting adapter.
6. You need to either glue or sweat the fitting before connection to the fitting on the bypass
7. The brass connection fitting that has to be sweat or glued is item 1 in both drawing below.
8. Once you have done this you will follow the procedures on installing the fitting adapters. These are items a
and b.
INSTALLING 7000 6