Advertisement
Quick Links
Installing Your Fleck 7000SE Water Softener
Adding resin to the tank.
Copyright © 2006 Quality Water Treatment, All right reserved.
The systems require that a 120 volt standard outlet be
available for powering the system. The 7000SE valve has
a 5' cord with a special low voltage transformer that will
plug into a standard 120 volt outlet.
Pre-Installation Adding the Resin to the Water Softener
Tank
1. Position your new softener unit in place, where you want
it to set.
2. Inside your Softener tank is a 1" or 1.25" Pvc tube "
called a pilot tube" Use a pvc slip cap or some duck tape
to temporarily plug this tube (this is to keep the resin from
going down the tube) Use the special funnel we supplied
you, to add the resin to the tank, this will take about 10
minutes to do. After adding the resin, remove the cap,
clean the threads on the tank with water were the valve
screws onto, and screw the valve on, the tube will slip into
the bottom of the valve hole as you are screwing that
valve onto the tank.
Page 1 of 7
www.qualitywatertreatment.com
Advertisement
Related Manuals for Fleck 7000SE
Summary of Contents for Fleck 7000SE
- Page 1 Installing Your Fleck 7000SE Water Softener The systems require that a 120 volt standard outlet be available for powering the system. The 7000SE valve has a 5' cord with a special low voltage transformer that will plug into a standard 120 volt outlet.
- Page 2 Screwing valve onto tank. Make a list of all the plumbing fittings you will need to completely install the unit to make it ready for operation. Typical is: • Two - 3/4" male adaptors • Eight - 90% elbows • The amount of pipe you need 1/2"...
- Page 3 NOTE: The unit will be marked either on the back of the valve body itself with the word "IN" and "OUT" and/or on the top of the body of the bypass valve assembly with arrows Remove PVC tales from bypass valve Wrap Threads on tales with Teflon tape Pick up two- 1”...
- Page 4 Brine Tank Float assembly: The float assembly is a safety float; it only comes into play if there are failures in the control valve to keep the brine tank from overflowing with water it does not dictate the water level in your brine tank. Measure from the top of the air check shown as # 6 in photo 10"...
- Page 5 Slide hose clamp over barb and tube and tighten the hose clamp. Plug your power cord into a nearby outlet. Plug the metering cable coming out the back of the 7000SE valve into the slot on the outlet side on top of the plastic turbine assembly. As shown in photo below.
- Page 6 Programming your 7000SE Softener Set: time of day temporarily to 12:01 PM the PM light has to be lit. This needs to be done in order to get into the programming. Hold up and down arrow in until DF comes up on screen Push extra cycle button H-9 = Harness of the water, push the up or down arrow until you get to the hardness of your water.
- Page 7 Filling your softener with water and purging air from softener: Turn all faucets off outside and in home. Slowly open bypass valve on 7000SE valve and let the mineral tank fill with water. When water stops running go to the nearest treated faucet to the Water Softener, unscrew aerator screen if applicable and turn cold water on slowly, this will bleed the air from the tank, let the water run until it clears.