Activating Default Setting; Delete All Programmes; Updating Software; Software Update - TechniSat S1 Operating Manual

Bed_anl_.qxd 20.02.04
(Fig. 8-11)
(Fig. 8-12)
16:29 Seite 54
(Fig. 8-21)
Use the up/down arrow keys to mark the menu line
>
Service settings.
Confirm by pressing OK.
>
The sub-menu Service settings will be displayed.
(Fig. 8-22)
8.5.1 Activate default setting
When this function is selected, the default settings pre-pro-
grammed at the factory are activated again, your own settings
are deleted, and the installation assistant AutoInstall will
be started.
Use the up/down arrow keys to mark the line
>
Activate default setting.
Press OK.
>
The following prompt will appear: "Do you really want
to activate the default setting?".
Use the left/right arrow keys to select Yes or
>
Abort.
Confirm your selection by pressing OK.
>

8.5.2 Delete all programmes

This function will delete all programme memory.
Use the up/down arrow keys to mark the line
>
Delete all programmes.
Press OK.
>
The following prompt will appear:"Do you really want
to delete all programmes?".
Use the left/right arrow keys to select Yes or
>
Abort.
Confirm your selection by pressing OK.
>

8.5.3 Updating software

In addition, you have the option of updating the operating
system software of your digital receiver via satellite (ASTRA
19° East).
Press OK to go to the sub-menu Software update
>
(Fig. 8-23).
To perform a software update, mark the line

Software update.

Press the OK key to switch the software update func-
>
tion to On.
In the line Update time use the numeric keys to
>
select the time at which the software update is to be
carried out.
> To start the updating of the operating software manual-
ly, press the red function key Test.
Press the Menu key to revert to normal operation.
>
Should the parameters of the data channel used for downloa-
ding the software updates have changed, these may be cor-
54