Download Print this page

Setting The Clock - KTM 690 Duke EU 2014 Setup Instructions

Hide thumbs Also See for 690 Duke EU 2014:

Advertisement

3
WORK
3.5

Setting the clock

3.6
Setting kilometers or miles
Info
If you change the unit, the value ODO is retained and converted accordingly.
Making the setting according to the country.
3.7
Refueling
Danger
Fire hazard Fuel is highly flammable.
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Note
Material damage Premature clogging of the fuel filter.
In some countries and regions, the available fuel quality and cleanliness may not be sufficient. This will result in problems with
the fuel system.
Only refuel with clean fuel that meets the specified standards.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
Do not allow fuel to get into the ground water, the ground, or the sewage system.
Condition
The motorcycle is stationary.
Switch on the ignition by turning the ignition key to the position
Press the MODE button repeatedly until the ODO mode is active.
Keep the MODE button and the SET button pressed simultaneously.
The time display begins to flash.
Press the MODE button to set the hour.
Press the SET button to set the minute.
Keep the MODE button and the SET button pressed simultaneously.
The time is set.
401444-01
Condition
The motorcycle is stationary.
Switch on the ignition by turning the ignition key to the position
Press the MODE button repeatedly until the ODO mode is active.
Keep the MODE button pressed until the display mode changes from km/h to mph or
from mph to km/h.
401444-01
7
.
.

Advertisement

loading