Advertisement
LAUNCH
TS971 User's Manual
1. By the power adaptor
1) Locate the device USB port.
2) Use the power adaptor to connect the device with the power
supply.
2. By the USB cable
1) Locate the device USB port.
2) Use the USB cable to connect the device with the computer.
Note: To get a best device performance, please keep the device fully
charged. Charge the device at least 2 hours before first use.
3) After charging, press the power button to start the device.
Power supplied by DLC
This TPMS diagnostic tool can be powered by vehicle DLC (Data
Link Connector) in addition to the rechargeable battery. Follow the
steps to start the device:
1. Connect one end of the diagnostic main cable to the diagnostic
interface of the device and tighten the screw.
2. Locate the vehicle DLC position. The DLC is usually a standard 16
pin connector. It is an interactive interface between the diagnostic
tool and the onboard computer. In most vehicles, the DLC is installed
on the driver side, 12inch under the instrument, please see below
picture.
39
Advertisement
